When I tested it here, the drop down did not contain the MSD visualizer that was running on another PC, that is why i included Chris Muenchow from wholehog. In the Visualizer settings of the HOG, there is a drop down box with Detected Visualizers. O Set the Visualizer IP Address to the correct ip In the HOG network settings, change the settings of the Visualizer.In the startup screen, select ‘Settings’ and enabling the ‘Run Visualizer Stream’.Setup the network correctly ( obviously ).We also had problems with the connection, and asked Wholehog but never got a satisfactory answer.Īfter some testing I was able to get the connection working by following these steps : You can check if you selected the correct DMX connection by clicking on the blue area in the status bar. The visualizer communicates with the HOG Connectivity driver to get the DMX values from the HOG, so that needs to be installed on the PC running MSD, and you need to select the external ‘HOG III PC Link’ in MSD ( using the ‘Show Control’ > Follow > ‘Select DMX Connection’ ) Stefan Montanus from LightHouse Support wrote a really good mail explaining how to setup this connection, here it is:
0 Comments
Leave a Reply. |